Installation of sink and precautions

Installation of sink and precautions

The kitchen is one of the most water-intensive areas in our daily lives, so we all pay attention to the installation of kitchen appliances, especially the pressing sink, during the renovation. Let's take a look at how the pressing sink is installed.

Here is the content:

• Step 1

• Step 2

• Step 3

• Step 4

• Test

Step 1

Set aside a good sink position, and provide the approximate size of the pressing sink when ordering the sink. Leave the right amount of space, as the amount of space reserved for a single bowl sink is different from that for a double bowl sink. It is best to have a sink plan to provide, so as not to order a discrepancy that leads to rework. When the sink is installed, the location of the countertop left should match the volume of the sink. The sink should be installed firmly, and the sink body should not be shaken from side to side. The pressing sink installation is not a big project in the whole renovation, but try to pay more attention to the sealing of the connection during the installation.

Step 2

The faucet and the inlet pipe should be installed before the pressing sink is installed. In addition, one end of the inlet pipe on the faucet is connected to the water inlet switch.

Step 3

After putting in the countertop, you need to install a matching pendant between the sink and the countertop. The sink should be installed firmly, and the pressing sink body should not be shaken from side to side. Sink installation is not a big project in the whole decoration, but try to pay more attention to the sealing of the connection during the installation.

The sealing degree of the overflow hole and the filter blue will affect the future use of the pressing sink, so the sealing degree of the overflow hole and the filter blue is very important, and it is important to check the sealing of the overflow hole and the filter basket after the installation.

Step 4

The last step is to install the matching sink hanging piece, generally, after the sink is bought the home, workers will cut the cabinet countertop according to the size of the pressing sink, into the countertop, you need to install the matching hanging piece between the tank and the countertop. Installation should avoid small gaps that lead to sinking body shaking better to prevent future leakage of water.

Test

Installation is complete: to do a drainage test, put the pressing sink full of water while testing the drainage of the water and overflow holes. Drainage if you find where there is water seepage, should be immediately reworked. After the drainage test, make sure there is no problem, you can seal the edge of the sink. When sealing the edge with silicone, make sure that the sink is connected to the countertop with an even seam and that there is no water seepage.

LiangShun Kitchen and bath Co., Ltd. develops different kinds of sink molds and conducts a lot of tests before leaving the factory to ensure the quality. If you need to buy a sink, you may consider using our cost-effective products.